Kenwood NEXEDGE NX-200 Function Reference page 257

9 NXDN TRUNKING SYSTEM
9.7 Making a Group Call (Transmission Trunked)
Display When the Transceiver Receives a Group Call (Group Call Display Type)
Group Call Display Type can be used to display the received information on the main display when the transceiver
receives a Group Call.
Configuration
The Group ID of the received Group Call appears.
If the ID Name is not configured in the Group ID List, the Group ID List number appears on the main display.
Group ID
If the transceiver receives a Status Message with Group Call, the Status Name appears for 3 sec and the Group
ID of the received Group Call appears for 2 sec alternately.
The Unit ID of the transmitting transceiver appears.
The stacked ID Name appears if the ID Name is stored for the Unit ID stacked in the transceiver. If the received
Unit ID is not in the stack memory, the ID Name configured for the Unit ID List appears if the ID Name of the
received Unit ID is configured in the Unit ID List. The Unit ID List number appears if the above conditions are not
Calling Transceiver
satisfied.
ID
If the transceiver receives a Unit ID Name, the received Unit ID Name will appear after 500 ms elapses upon
appearance of the Unit ID. If the transceiver receives a Status Message with Group Call, the Status Name
appears for 3 sec and the Unit ID of the transmitting transceiver appears for 2 sec alternately.
If the transceiver receives a Group Call from a telephone, "PHONE CALL" appears.
The Group ID of the received Group Call and the Unit ID of the transmitting transceiver appear alternately.
If the transceiver receives a Status Message with Group Call, the Status Name appears for 3 sec, and the Group
Calling Transceiver
ID of the received Group Call and the Unit ID of the transmitting transceiver appear for 2 sec alternately.
ID/Group ID
If the transceiver receives a Group Call, the Group ID of the received Group Call and "PHONE CALL" appear
alternately.
Note
• This function can be used with the Group Call (Message Trunked (Enhanced)) and the Broadcast Group Call.
• This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Group Call Display Type (
Preventing the Functions Working with Group Call Reception from Activating (Call
Alert Inhibit (Group Calls Only))
Call Alert Inhibit (Group Calls only) is the function that disables the Alert Tone, Selective Call Alert LED, Horn Alert,
Vibrator and Caller ID Stack functions when the transceiver receives a Group Call.
Use of this function prevents specific functions from activating as follows even if these functions are enabled or configured
to be enabled when the transceiver receives a Group Call.
• Alert Tone
The following Alert Tones do not sound from the transceiver even if the transceiver receives a Group Call.
Alert Tone (Zone Information)
Conference Group Call (Alert Tone) (Trunking)
Broadcast Group Call (Alert Tone) (Trunking)
• Selective Call Alert LED
A Selective Call Alert LED does not blink even if the transceiver receives a Group Call.
• Horn Alert (Mobile only)
The headlights or the horn of a vehicle being connected to the Horn Alert port does not light or sound even if the
transceiver receives a Group Call.
FUNC (K)/Ver 4.00
Table 9-6 Group Call Display Type
Description
See FPRG 8.19.2 General 1 Tab)
CONTENTS INDEX 223