CHAPTER 3: CONFIGURING THE D20E FIRMWARE
Delete a project
Configuring D20E modules
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
To delete a project:
1.
Open DAPserver Studio.
2.
Hover on an existing project from the My Devices section of the DAPserver Studio
main window and select the check-box.
3.
Confirm that the project you wish to delete is selected. (that is, a check-mark appears
in the top-right of the device box.
4.
Click Delete (trash can).
Result: A message window appears asking if you would like to delete the project you
have selected.
5.
Click Yes.
Result: The project is removed from DAPserver Studio.
This section describes how to configure D20E modules. This comprises how to:
•
Configure NTP time sync
•
Change an existing user's password
•
Change an existing user's permissions
For detailed information on configuring the point types, see section
page 55.
on page 50
on page 51
on page 53
GE INFORMATION
Configuring points
on
49