D20E Ethernet I/O Module
Appendix F: Frequently Asked
Questions
Questions and answers
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
Frequently Asked Questions
This appendix answers some frequently and commonly asked D20E questions:
•
How do you configure the double Digital Input points?
•
How do you identify what D20E configuration is currently running?
•
How do you configure a Counter?
•
How do you set the Analog Input to match the legacy hardware (signed 16 bit
integer)?
•
How do you operate a R/L (raise/lower) Digital Output point)?
•
How do you operate control output points?
•
How do you access the system status information?
•
How do you access the Event Log?
•
How do you test previously configured input/output points using DAPserver Studio?
•
How do you setup Time Synchronization?
Q:
How do you configure the double Digital Input points?
A:
Refer to section:
Double digital input configuration procedure
configuration procedure.
Q:
How do you identify what D20E configuration is currently running?
A:
Method 1: To view the firmware version using DAPserver Studio:
1.
Go to Device menu > Explore tab.
Result: The Explore window appears.
2.
Scroll down the main (top) window displayed for SYSTEM, REAL-TIME info
3.
Observe the information for the FMWVER line item.
GE INFORMATION
on page 59 for this
139