Table of Contents
Advertisement
Firmware update
Clock setting
Time synchronization
118
When required, D20E module firmware updates are made available. These updates may
provide new functions, new features or improvements.
The D20E Ethernet I/O Module is delivered with a version of DAPserver Studio firmware.
Before you can update the configuration of a D20E module, the latest version of DAPserver
Studio must be running on the D20E.
Refer to section:
Update firmware
The D20E module local clock can be set with a Linux standard command.
To set the clock with a Linux Command:
1.
Power up the D20E module.
2.
Connect a cable with a USB micro AB plug between a PC and the D20E module USB
2.0 LAN port. See section:
3.
Run a terminal emulator program.
4.
Connect to the D20E module at 10.0.0.1:22 with SSH encryption.
Result: The console prompt appears: #.
5.
Execute the date command: # date -s "25 OCT 2017 10:00:00"
6.
Execute the date command: # date to ensure that the clock has been changed.
The D20E module can be time synchronized with an NTP time source on the network. See
section:
Configure NTP time sync
DO NOT use both DNP and NTP time sync simultaneously.
GE INFORMATION
CHAPTER 11: SERVICING THE D20E MODULE HARDWARE
on page 111 for the procedure to update the firmware.
Console port
on page 78.
on page 50.
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
Advertisement
Table of Contents
