Start DAPserver Studio
40
DAPserver Studio is used to access and configure the D20E module. For further
information on DAPserver Studio, refer to appendix:
To start DAPserver Studio:
1.
Double-click on the DAPserver Studio desktop icon.
If the icon does not appear on the desktop, navigate to Windows Start > All Programs
> DAPserver Studio and click on the DAPserver Studio icon.
Result: The Start screen appears.
2.
Create a New D20E project or select a D20E project from My Devices ore the Recent
list.
3.
On the right side of the screen select Device > Explore.
Result: The Device Information window appears.
4.
Type in the actual IP Address of the D20E module.
5.
Type in the Username and Password login credentials (default: admin).
6.
Click OK.
Result: The upper-right LAN connection icon should show Connected in green.
7.
Ensure that the:
–
PC Ethernet port used to communicate with D20E module is configured to be on
the same subnet as the D20E module.
–
The IP address configured in DAPserver Studio must match the IP address in the
D20E module for a successful connection. The default IP addresses for DAPserver
Studio projects and the D20E module LAN 1 are 192.168.0.189.
Result: For example, the Explore window can appear as shown in Figure 7.
GE INFORMATION
CHAPTER 3: CONFIGURING THE D20E FIRMWARE
DAPserver Studio
on page 125.
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL