Table of Contents
Advertisement
122
Standard Name
Description
IEC 61000-4-6
Immunity to conducted disturbances,
induced by radio-frequency fields
IEC 60255-22-6
IEC 61000-4-8
Power frequency magnetic field immunity
test
IEEE C37.90.1
Temperature Testing: Operational Test
IEEE C37.90.1
Temperature Testing: Non-operational
Test
IEC 61000-4-16
Test for immunity to conducted, common
mode disturbances in the frequency
range 0 Hz to 150 kHz
IEC 61000-4-17
Ripple on DC input power port immunity
test
IEC 61000-4-18
Ring wave immunity test
IEEE C37.90.1 SWC
Damped oscillatory wave immunity test
IEC 61000-4-29
Voltage dips, short interruptions and
voltage variations on DC input power port
immunity test
Table 42: Safety publications
Standard Name
Description
IEC 61010-1
Safety requirements for electrical
equipment for measurement, control and
laboratory use - General requirements
IEC 60255-5
Insulation coordination for measuring
relays and protection equipment-
Requirements and tests
Table 43: Environmental standards
Standard Name
Description
IEC 60068-2-1
Cold
IEC 60068-2-2
Dry Heat
IEC 60068-2-6
Vibration (sinusoidal)
IEC 60255-21-1
IEC 60068-2-27
Shock - Operating Response Test
IEC 60255-21-2
Shock - Non-Operating Withstand Test
Bump – Non operating test
IEC 60068-2-31
Drop and topple
IEC 60068-2-78
Humidity Testing
GE INFORMATION
APPENDIX A: STANDARDS & PROTECTION
Test Specification
150kHz to 80 MHz, 10 V
50/60 Hz, 100 A/m
DC - 150 kHz CM 3/30 V
15%
±2.5 kV CM/TM
30/60/100% @ 24 VDC
Test Specification
Insulation Resistance >100 MΩ
Insulation Dielectric 0.7/2.8 kVDC
Insulation Impulse 1/5 kV
Test Specification
2 hours non powered, soak at −40
°C, then warm to −20 °C and leave
powered for 16 hours
16 hours powered at +70 °C
A logarithmic sweep from 10 Hz to
150 Hz to 10 Hz at 1 oct/min for 1
sweep cycle in the 3 orthogonal
axes.
Acceleration level 1 g
Pulse shape: Half sine Pulse
duration: 11 mS
- Operating Response Test:
Acceleration level: 5 g's
- Non-Operating Withstand Test:
Acceleration level: 15 g's
3 pulses per polarity per axis for a
total of 18 pulses
Pulse shape: Half sine Pulse
duration: 11 mS Acceleration level:
10 g's
1000 pulses per polarity per axis for
a total of 6000 pulses
Dropping on each face Dropping on
each corner Toppling (or pushover)
For a total of 12 drops, 50 mm
96 hours steady state humidity at
40 °C and 93% RH
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
rms
100 A/m, 1 sec
rms
pk
Advertisement
Table of Contents
