3.
Assemble the casters to the cutting unit with a
shim on both sides of the caster shaft hub as
shown in
Figure
8.
Note:
You can adjust the height-of-cut setting
by changing the amount of spacers on either
side of the caster shaft hub; refer to
the Height of Cut (page
Figure 8
1. Tensioning cap
2. HoC spacers
3. Shim
4.
Ensure that the deck is level; move the deck to
a level surface and place a level horizontally
across the top of the deck.
5.
If the deck is not level, position the shims on the
caster shaft accordingly until it is level.
Adjusting
17).
g319438
4. Caster shaft hub
5. Caster wheel shaft
3
Installing the Debris Guard
to the Front Axle
Parts needed for this procedure:
1
Debris guard
1
Bracket
5
Rivet
Procedure
Use 5 rivets to install the bracket and debris guard to
the front axle
(Figure
Left side shown
1. Bracket
2. Debris guard
9
9).
Figure 9
3. Rivet
g383702