Setup; Preparing The Machine - Toro 02835 Operator's Manual

Setup

1

Preparing the Machine

No Parts Required
Procedure
Note:
Retain all removed parts unless otherwise
noted.
1. Park the machine on a level surface, disengage
the PTO, move the lift arms to the lowest
position, engage the parking brake, shut off the
engine, and remove the key.
2. Wait for all movement to stop and allow the
machine to cool before adjusting, cleaning,
storing, or repairing it.
3. If a cutting unit is equipped, remove the cutting
unit from the machine lift arms; refer to your
cutting unit Operator's Manual.
4. Ensure that the PTO driveshaft is aligned
correctly; refer to the PTO-driveshaft alignment
procedure in your traction unit Operator's
Manual.
Important:
If the markings on the driveshaft
are not aligned, severe imbalance may occur
in the driveline system.
5. If the lift arms for the rotary cutting unit are
installed on the traction unit, remove the lift arms
as follows:
A. Raise the front of the machine and remove
the front wheels from the machine; refer to
your traction unit Operator's Manual.
B. Remove the 2 carriage bolts and 2 nuts (3/8
inch) that secure the sensor bracket to the
right lift arm
C. Remove the 2 bolts (3/8 x 1-1/4 inches), 2
nuts (3/8 inch), and 2 small pins that secure
the lift arms to the cylinders
D. Remove the nut and bolts securing the large
pins to the lift arms as shown in
E. Remove the lift arms and large pins from
the machine frame
(Figure 3).
(Figure
Figure
(Figure 5).
1. Bolt (3/8 x 1-1/4 inches)
2. Small pin
3. Nut (3/8 inch)
1. Nut
2. Large pin
3).
4.
7
Figure 3
4. Carriage bolt
5. Sensor bracket
Figure 4
Right side shown
3. Bolt
g300498
g295767