Table of Contents
Advertisement
4
Installing the Cutting Unit
to the Machine
Parts needed for this procedure:
2
Lift arm
2
Large pin
2
Long bolt (3/8 x 2-3/4 inches)
6
Nut (3/8 inch)
2
Small pin
2
Bolt (3/8 x 1-1/4 inches)
2
Carriage bolt (3/8 x 1-1/4 inches)
2
Socket-head capscrew (3/8 x 2-1/4 inches)
2
Washer (3/8 inch)
2
Flange-locknut (3/8 inch)
2
Lift arm pin
2
Lynch pins
1
Sensor bracket
Procedure
1.
Raise the front of the machine and remove
the front tires from the machine; refer to your
traction unit Operator's Manual.
2.
Install the lift arms and large pins to the machine
frame
(Figure
10).
Figure 10
Right side shown
1. Lift arm
2. Machine frame
g317790
3. Large pin
3.
Secure the large pin to the lift arm using a pair
of nuts and bolts as shown in
1. Nut (3/8 inch)
2. Large pin
4.
Secure each cylinder-rod end to the each lift
arms with a small pins, bolts (3/8 x 1-1/4 inches),
and nut (3/8 inch) as shown in
Note:
Manually rotate the lift arm to align it with
the cylinder-rod end.
5.
Secure the sensor bracket to the right lift arm
using 2 carriage bolts and 2 nuts (3/8 inch) as
shown in
Figure
1. Bolt (3/8 x 1-1/4 inches)
2. Small pin
3. Nut (3/8 inch)
10
Figure
11.
Figure 11
3. Long bolt (3/8 x 2-3/4
inches)
Figure
12.
12.
Figure 12
4. Carriage bolt
5. Sensor bracket
g317791
g383542
Advertisement
Table of Contents
