Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
WARNING
If you leave the key in the ignition switch,
someone could accidentally start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
lever when the PTO shaft is not connected to
the gearbox on the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Description
No parts required
Debris guard
Bracket
Rivet
Hex-head bolt
Washer
Height-of-cut pin
Shoulder bolt
Spacer
No parts required
No parts required
Qty.
–
Prepare the machine.
1
1
Install the debris guard to the front axle.
5
2
2
Install the cutting unit to the traction unit.
2
2
Install the PTO cover.
2
–
Level the cutting unit.
–
Grease the cutting unit.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
7
Use