:FRESistance
Parameters
Comments
Example
90 Multimeter Command Reference
CONFigure:FRESistance [<
[,<
resolution
>|MIN|MAX|DEF]]
specify the measurement range and resolution.
Parameter Name
Parameter Type
range
<
>
resolution
<
>
•
To select a standard measurement range, specify range as the input signal's
maximum expected resistance. The multimeter then selects the correct range
that will accept the input.
•
The
or
AUTO
DEFault
DEFault
option for resolution defaults the integration time to 10 PLC.
•
The
MIN
and
MAX
range and resolution:
For range:
MIN
= 100Ω;
For resolution:
MIN
selected range.
MAX
selected range.
•
To select autorange, specify
range and resolution parameters. In the autorange mode, the multimeter
samples the input signal before each measurement and selects the appropriate
range.
•
To specify a
MIN
or
specify the
AUTO
or
CONF:FRES DEF,MAX
CONF:FRES AUTO,MAX
prevents the
MIN
or
•
Related Commands:
Making 4-Wire Ohms Measurements
CONF:FRES 1500,MAX
SAMP:COUN 3
READ?
enter statement
range
>|MIN|MAX|DEF|AUTO
selects the 4-wire ohms function and allows you to
Range of Values
numeric
100Ω|1kΩ|10kΩ|100kΩ|1MΩ
|10MΩ|100MΩ|
MIN|MAX|DEF|AUTO
numeric
resolution
option for the range parameter enables autorange. The
parameters select the minimum or maximum values for
MAX
=100MΩ
selects the best resolution (the smallest value) for the
selects the worst resolution (the largest value) for the
DEF
for range or do not specify a value for the
MAX
resolution while autoranging, you must
DEFault
parameter;
CONF:FRES DEF,MIN
or
CONF:FRES AUTO,MIN
(you cannot omit the range parameter). This
MAX
resolution from being interpreted as a range setting.
FETCh?
,
INITiate
,
READ?
Function: 4-wire ohms; range selected: 10kΩ;
MAX resolution: 1Ω.
Take 3 readings; trigger source is IMMediate
by default.
Place multimeter in wait-for-trigger state and
make measurements; send readings to output
buffer.
Enter readings into computer.
Default Units
ohms
ohms
|MIN|MAX|DEF
or
or
Chapter 3