[Sense:] - HP E1312A User Manual

Subsystem Syntax
116 Multimeter Command Reference
The command subsystem is most commonly used with

[SENSe:]

change specific "low-level" measurement parameters.
change the following measurement parameters, predefined by the
command, without completely reconfiguring the multimeter.
-- Function, Range and Resolution
-- Aperture Time and Number of Power Line Cycles
-- Bandwidth
-- Autozero
[SENSe:]
FUNCtion "CURRent:AC"
FUNCtion "CURRent[:DC]"
FUNCtion "FREQuency"
FUNCtion "FRESistance"
FUNCtion "PERiod"
FUNCtion "RESistance"
FUNCtion "VOLTage:AC"
FUNCtion "VOLTage[:DC]"
FUNCtion "VOLTage[:DC]:RATio"
FUNCtion?
CURRent
:AC:RANGe <
:AC:RANGe? [MIN|MAX]
:AC:RANGe:AUTO OFF|ON
:AC:RANGe:AUTO?
:AC:RESolution <
:AC:RESolution? [MIN|MAX]
[:DC]:APERture .333ms|3.33ms|16.7ms|167ms|1.67s|MIN|MAX
[:DC]:APERture? [MIN|MAX]
[:DC]:NPLCycles .02|.2|1|10|100|MIN|MAX
[:DC]:NPLCycles? [MIN|MAX]
[:DC]:RANGe <
[:DC]:RANGe? [MIN|MAX]
[:DC]:RANGe:AUTO OFF|ON
[:DC]:RANGe:AUTO?
[:DC]:RESolution <
[:DC]:RESolution? [MIN|MAX]
DETector
:BANDwidth 3|20|200|MIN|MAX
:BANDwidth? [MIN|MAX]
FREQuency
:APERture 0.01|0.1|1|MIN|MAX
:APERture? [MIN|MAX]
:VOLTage:RANGe <
:VOLTage:RANGe? [MIN|MAX]
:VOLTage:RANGe:AUTO OFF|ON
:VOLTage:RANGe:AUTO?
range
>|MIN|MAX
resolution > |MIN|MAX
range >|MIN|MAX
resolution
>|MIN|MAX
range >|MIN|MAX
[SENSe:]
to
CONFigure
enables you to
[SENSe:]
CONFigure
Chapter 3