Configure - HP E1312A User Manual

Subsystem Syntax
Chapter 3
The command subsystem configures the multimeter to perform the

CONFigure

specified measurement with the given range and resolution.
make the measurement after setting the configuration. Executing
equivalent to setting the multimeter configuration as follows:
Command
RANGe
RESolution
AC filter
([SENSe:]DET:BAND)
Autozero
([SENSe:]ZERO:AUTO)
Input resistance
([SENSe:]INP:IMP:AUTO)
Samples per trigger
(SAMP:COUN)
Trigger count
(TRIG:COUN)
Trigger delay
(TRIG:DEL)
Trigger source
(TRIG:SOUR)
VM Complete routing
n
(OUTP:TTLT< >:STAT)
Math function
(CALCulate:STATe)
After configuring the multimeter, use the
in the wait-for-trigger state and store readings in the multimeter's internal memory.
Or, use the command to make the measurement and send the readings to the
READ?
output buffer when the trigger is received.
CONFigure
range
:CURRent:AC [<
:CURRent[:DC] [< range
range
:FREQuency [<
range
:FRESistance [<
:PERiod [< range >|MIN|MAX|DEF|AUTO[,<
:RESistance [< range
:VOLTage:AC [< range
[:VOLTage[:DC]] [<
[:VOLTage[:DC]]:RATio [<
The CONFigure command
will get the default range and resolution settings if you do not specify a range or
resolution in the command. You will get these default settings even if you set a range
As specified (or AUTO).
As specified, or as a function of range, integration
time, or NPLCs.
20 Hz - 300 kHz (medium filter)
OFF if resolution setting results in NPLC <1;
ON if resolution setting results in NPLC ≥1
Applies to dc voltage and is disabled for all other
functions. 10MΩ for all dc voltage ranges.
1 sample
1 trigger
AUTO (Automatic delay)
IMM (trigger signal is always true)
OFF (all trigger lines;
OFF
INITiate
>|MIN|MAX|DEF|AUTO[,<
>|MIN|MAX|DEF|AUTO[,<
>|MIN|MAX|DEF|AUTO[,<
>|MIN|MAX|DEF|AUTO[,<
resolution
>|MIN|MAX|DEF|AUTO[,<
>|MIN|MAX|DEF|AUTO[,<
range >|MIN|MAX|DEF|AUTO[,<
range >|MIN|MAX|DEF|AUTO[,<
RANGe and RESolution
Multimeter Command Reference
CONFigure
does not
CONFigure
CONFigure
Setting
n = 0 - 7)
command to place the multimeter
resolution
>|MIN|MAX|DEF]]
resolution
>|MIN|MAX|DEF]]
resolution
>|MIN|MAX|DEF]]
resolution
>|MIN|MAX|DEF]]
>|MIN|MAX|DEF]]
resolution >|MIN|MAX|DEF]]
resolution >|MIN|MAX|DEF]]
resolution >|MIN|MAX|DEF]]
resolution >|MIN|MAX|DEF]]
parameters are optional. You
is
85