Voltage:ac:range - HP E1312A User Manual

Example

VOLTage:AC:RANGe

Parameters
Comments
Example
VOLTage:AC:RANGe?
144 Multimeter Command Reference
Query the Resolution
RES:RES 10E-03
RES:RES?
enter statement
[SENSe:]VOLTage:AC:RANGe <
voltage measurements.
Parameter Name Parameter Type
range
< >
•
To select a standard measurement range, specify range as the input signal's
maximum expected voltage. The multimeter then selects the correct range.
•
MIN selects the minimum range available with the
command: 100mV.
•
You must select a range using
resolution.
•
Specifying a fixed range disables the autorange mode setting
VOLT:AC:RANG:AUTO OFF
•
The VOLT:AC:RANG
command specifying the same function. With the new range, a
CONFigure
new resolution is also selected.
•
Condition:
*RST
Change the Range
CONF:VOLT:AC 01.05,MAX
VOLT:AC:RANG 1
READ?
enter statement
[SENSe:]VOLTage:AC:RANGe? [MIN|MAX]
to the output buffer:
•
The present voltage range selected if
ranges available with the
CONFigure selects the 10V range, 10V is the range returned.
•
The minimum voltage range available with the
command (100mV) if
•
The maximum voltage range available with the
command (300V) if
Set resolution to 10 mΩ.
Query multimeter to return the present resolution.
Enter value into computer.
range > selects the range for AC-coupled RMS
Range of Values
numeric 100mV|1V|10V|100V|300V|
MIN|MAX|DEF
selects the maximum range available: 300V.
MAX
VOLTage:AC:RANGe
.
command overrides the range setting from a previous
VOLT:AC:RANG 10V
Function: AC volts; range selected: 10V.
Range selected: 1V.
Place multimeter in wait-for-trigger state and make
measurement; send readings to the output buffer.
Enter readings into computer.
returns one of the following numbers
or
MIN
RANGe command are returned. For example, if
is specified.
MIN
is specified.
MAX
Default Units
VOLTage:AC:RANGe
before specifying
is not specified. Only the
MAX
VOLTage:AC:RANGe
VOLTage:AC:RANGe
Chapter 3
volts