NorthStar 957 Operator's Manual page 128

Chapter 10 - Using Special Functions
YOUR ANCHOR
MAY BE DRAGGING
YOU'VE ARRIVED
AT WAYPT: 'NAME'
Page 120
are auto-clearing; however, they can also be manually
cleared, if desired.
•
Alarms that require manual clearing - These will stay
onscreen until you clear them on the ALARMS screen.
All of the 957's alarms are described in Table 6 below.
The following abbreviations are used in Table 6.
For alarm message, 'NAME' = name of waypoint.
For "must be cleared,", N = no, Y = yes
Table 6: 957 alarms
Vessel has moved outside the radius limit
ANCHOR
set in the
shown only if you've turned it on at the
ALARMS
screen and you have pressed
DROP ANCHOR
the
Vessel has entered the arrive radius of an
active waypoint. This alarm is shown only
if you've chosen manual waypoint switch-
ing, or when you're navigating to a single
waypoint.
NOTE:
alarm. This alarm is
key.
Does not time out.
Within 10 seconds.
957 Operator's Manual, Rev. B
Y
N