NorthStar 957 Operator's Manual page 104

Chapter 7 - Understanding the Routes Function
Page 96
the parentheses indicating the waypoint is part of a saved
route and the four-digit number uniquely identifying
each waypoint).
4. Repeat these steps for each new waypoint or cursor loca-
tion you want to insert in the route.
5. When done, to change to adding waypoints to the begin-
ning or end of a route, press the CANCEL INSERT menu
key. To go to list-based editing, press the RETURN menu
key. To go back to the CHART screen, press the CHART
key.
Adding waypoints to the end of a route
To add waypoints to the end of a route:
1. Move the CURSOR PAD to select the last waypoint in the
route.
2. Press ADD TO END menu key, then move the cursor to
the existing waypoint or other location that you want to
add to the end of the route. As you move the cursor, the
957 displays the new route leg as a dotted line from that
last waypoint to the cursor position.
3. If you've selected an existing waypoint, press the ADD
WAYPT menu key. If you've selected only a cursor posi-
tion, press the ADD NEW WP menu key (in this case, this
waypoint is stored with a name similar to (0001), with the
parentheses indicating the waypoint is part of a saved
957 Operator's Manual, Rev. B