Toro Greensmaster e1021 Diagnostic Manual page 56

A. Move the key switch to the O
B. Disconnect the battery. Refer to
C. Verify that the battery charger is turned off.
D. Connect the battery charger to the battery and charge the battery.
E. Disconnect the battery charger and reconnect the battery to the machine.
F. Turn on the machine by rotating the key switch to the O
G. Look at the InfoCenter and see if the fault has repeated.
H. Shut off the machine by rotating the key switch to the O
Pass The fault did not repeat. Go to
listed.
Fail The fault repeated. Go to Step 3.
Step 3: Replace the motor.
1. Verify that the key switch is in the O
2. Disconnect the battery. Refer to
3. Replace the motor. You can obtain more information about installing and removing a motor in the
machine's service manual (Greensmaster® e1021/e1026 Service Manual or Greensmaster® eFlex®
1021 Service Manual).
Step 4: Use Toro DIAG to program the replacement motor.
1. Connect the battery. Refer to
2. Move the key switch to the O
3. Connect a PC with Toro DIAG software to the machine through a Toro DIAG cable (Part No. 115-1944).
Refer to Toro DIAG–Quick Start (page
4. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement motor is programmed during the reprogramming of the machine.
5. Disconnect the Toro DIAG cable from the machine.
6. Go to Returning the Machine to Service (page 20)
position.
FF
Connecting and Disconnecting the Battery (page
Returning the Machine to Service (page 20)
position.
FF
Connecting and Disconnecting the Battery (page
Connecting and Disconnecting the Battery (page
position.
N
18).
and follow the steps listed.
56
position.
N
position.
FF
and follow the steps
14).
14).
14).