Toro Greensmaster e1021 Diagnostic Manual page 28

4. Remove the control cover. Refer to
1. Hour meter
2. Control cover
5. Unplug harness connector P43 from the hour meter connector.
6. Turn on the machine by rotating the key switch to the O
7. Look at the InfoCenter and see if the fault is still repeating.
8. Shut off the machine by rotating the key switch to the O
The The hour meter is not causing the fault.
fault
1. Leave harness connector P43 unplugged.
repeats
2. Do not install the control cover at this time.
3. Go to Step 5.
The The hour meter is causing the fault.
fault
1. Install a new hour meter.
does
not 2. Install the control cover.
repeat
3. Install the white electric cover.
4. Go to
Removing the Control Cover (page
Returning the Machine to Service (page 20)
Figure 20
3. Harness connector P43
4. Hour meter connector
position.
N
position.
FF
and follow the steps listed.
28
16).
g365094