Table of Contents
Advertisement
7
Installing and Replacing Components Other than Network Interface Cards (NICs) and Accelerated Data Path
Figure 22 Slot 3 PC Card Location
To install the single-slot PCMCIA carrier card
To install a single-slot PCMCIA carrier card, you need:
Physical access to the appliance
A Check Point single-slot PCMCIA carrier card
Access to the appliance by using Check Point Network Voyager or the CLI
Caution
To avoid potential equipment malfunction, Check Point recommends that you obtain
flash-memory PC cards only from Check Point or authorized resellers. For further
information, see the Check Point Web site at www.checkpoint.com.
Note
Because power to an IP2450 is automatically disconnected when the chassis assembly is
opened, you do not need to manually disconnect the power for this procedure. Any servicing
of the appliance, however, should be completed with the chassis assembly fully removed
from the appliance.
1. Use Check Point Network Voyager or the CLI to perform an orderly shutdown of the
IP2450.
For information about how to access Check Point Network Voyager and the related
reference materials, see
96
SLOT 1
SUB SLOT 1
SUB SLOT 2
LINK
LINK
LINK
ACT
ACT
ACT
SUB SLOT 1
SUB SLOT 2
LINK
ACT
SLOT 2
SLOT 3
PC CARD
"Using Check Point Network Voyager"
Check Point IP2450 Security Platform Installation Guide
FIO CARRIER
POWER
HOT SWAP
LINK
ACT
READY
REQUEST
FIO CARRIER
LINK
POWER
HOT SWAP
ACT
READY
REQUEST
SLOT 4
1
PC card slot
2
3
4
00617.1
on page 42.
Advertisement
Table of Contents
