Nokia Check Point IP2450 Installation Manual page 71

To install an ADP module in IP2450 appliances
For information about how to install or replace Check Point ADP module in your appliance, see
Chapter 4, "Installing and Replacing Network Interface Cards and ADP Modules."
few differences between the procedures for installing and replacing IP2450 PMC NIC card
carriers and ADP modules other than the following steps and considerations:
Before you remove your PMC NIC card carriers and replace them with your ADP module,
do the following:
Remove the installed PMC card carrier for a slot that you are installing ADP modules in. For
the card carrier removal procedure, see
Interface Cards and ADP
Note
You must first power down your appliance before you remove any installed card carriers.
Caution
When you install an ADP module, take care not to scrape the bottom surface, as this
can damage the device.
After you slide the ADP module into the carrier slot, secure the two screws and ensure that
both of the ejector and locking levers are fully secured.
After you physically install the ADP module, reboot the system and reconfigure the
interfaces as described in
page 76.
The following figure shows the fiber and copper IP2450 Gigabit Ethernet ADP modules and
card carrier assemblies.
Note
Hot Swap switch functionality is not supported by Check Point IPSO at the time of this
guide's publication. The RDY LED, however, illuminates during booting and then turns off.
Check Point IP2450 Security Platform Installation Guide
You cannot preserve the configuration for slots 1 and 2 of your appliance when you
replace a PMC NIC card carrier with an ADP module or, conversely, when you replace
your ADP module with a PMC NIC card carrier due to interface naming convention
differences. Therefore, you need to delete all existing configurations associated with any
affected slots.
Upgrade the Check Point IPSO software to the required version as described in the
Getting Started Guide and Release Notes that you received with your ADP module.
Modules.".
"Configuring Check Point IPSO for IP2450 ADP Interfaces"
Installing and Replacing ADP Modules
Chapter 4, "Installing and Replacing Network
There are
on
71