Table of Contents
Advertisement
6
About IP2450 Appliance ADP Services Modules
Reconfiguring Interfaces
After you install the ADP module, you need to reconfigure interface information as described
below.
To reconfigure interfaces for ADP modules
1. Log into the appliance using Check Point Network Voyager.
2. Navigate to the Interface Configuration page.
The removed interfaces are still listed on this page, and you see a blue indicator next to each
of them in the Up column.
Also notice that the ADP logical interfaces are named eth-s2p1c0 through eth-s2p12c0:
80
Check Point IP2450 Security Platform Installation Guide
Advertisement
Table of Contents
