Table of Contents
Advertisement
About this Guide
This manual provides information for the installation and use of the Check Point IP2450 security
platforms. Installation and maintenance should be performed by experienced technicians or
Check Point-approved service providers only.
This preface provides the following information:
In this Guide
Conventions this Guide Uses
In this Guide
This guide is organized into the following chapters and appendixes:
Chapter 1, "Overview"
Platform.
Chapter 2, "Installing the Check Point IP2450 Appliance"
Point IP2450 appliance.
Chapter 3, "Performing the Initial Configuration"
network and to a power source and how to make the appliance available on the network.
Chapter 4, "Installing and Replacing Network Interface Cards and ADP Modules"
how to install, monitor, and replace network interface cards (NICs) and Check Point
Accelerated Data Path (ADP) services modules for IP appliances.
Chapter 5, "About IP2450 Appliance Network Interface Cards"
and use each of the supported NICs.
Chapter 6, "About IP2450 Appliance ADP Services Modules"
and use each of the supported ADP modules.
Chapter 7, "Installing and Replacing Components Other than Network Interface Cards
(NICs) and Accelerated Data Path (ADP) Services Modules"
replace parts, other than NICs and ADP modules, that you can order from Check Point.
Chapter 8, "Troubleshooting"
solutions to these problems.
Appendix A, "Technical Specifications"
characteristics.
Appendix B, "Compliance Information"
Check Point IP2450 Security Platform Installation Guide
presents a general overview of the Check Point IP2450 Security
discusses problems you might encounter and proposes
provides technical specifications such as interface
provides compliance and regulatory information.
describes how to install the Check
describes how to physically connect it to a
describes how to connect to
describes how to connect to
describes how to install or
describes
11
Advertisement
Table of Contents
