Identifying Adp Module And Transceiver Types With Latch Lever Color Codes; Check Point Adp Module Led Reference Information; Table 9 Identifying Adp Modules And Transceivers - Nokia Check Point IP2450 Installation Manual

of rejected interfaces on the Interface Configuration page in Check Point Network Voyager, as
shown in the following figure.
Note
The Non-Supported Components table appears only if you have ADP transceivers installed
that are not supported by Check Point.
Identifying ADP Module and Transceiver Types with Latch
Lever Color Codes
To identify the types of ADP modules and transceivers you are using, refer to the color of the
latch levers as described in the following table.

Table 9 Identifying ADP Modules and Transceivers

Type
RJ-45 Gigabit Ethernet ADP modules
Gigabit Ethernet short range
Gigabit Ethernet long range
10 Gigabit Ethernet short range
10 Gigabit Ethernet long range

Check Point ADP Module LED Reference Information

All Check Point IP2450 ADP modules provide two LEDs for each port to indicate Link and
Activity status. For information about the LEDs, see
Check Point IP2450 Security Platform Installation Guide

Identifying ADP Module and Transceiver Types with Latch Lever Color Codes

Latch lever color
Yellow
Black
Blue
Beige
Blue
Figure 20 on page 73.
75