Table of Contents
Advertisement
The following figure shows the example system after the configuration information for all of
the removed interfaces has been deleted:
9. If appropriate, configure the ADP interfaces to use the IP addresses previously assigned to
the removed interfaces.
In this example, you need to assign the address 10.1.1.1 to the new interface eth-s2p1c0.
Reconfiguring VRRP
After you finish reconfiguring interfaces, you need to reconfigure any protocols and features
that used the removed interfaces to use the ADP interfaces.
In this example, you need to recreate the VRRP configuration using the new interfaces
Check Point IP2450 Security Platform Installation Guide
Configuring Check Point IPSO for IP2450 ADP Interfaces
83
Advertisement
Table of Contents
