Finish the output
How to punch or staple the output
Place the originals face up into the ADF, or place 1 original face down on the glass plate.
1.
Touch 'Jobs' -> 'Copy/Scan' -> 'Copy job'.
2.
At the 'Binding' setting, select the required number of staples and the location of the
3.
staples.
At the 'Punching' setting, select the required number of holes.
4.
At the 'Folding' setting, select the folding method.
5.
At the 'Trimming' setting, define the trim settings
6.
If required, define the other settings for the original document and the output.
7.
Enter the generic values in the 'Job' section.
8.
Touch 'Start' .
9.
Finish the output
Chapter 7 - Copy jobs
211