ABB ACS5000 User Manual page 151

ABB
Name
PC ETH 1 Off
Green
1/2-second
blinking green
1-second
blinking green
Blinking yellow
PWR Off
Green
Yellow
STAT Green
Yellow
1/4-second
blinking yellow
1-second
blinking yellow
Blinking red
MON Blinking green
Blinking red
5k A UM
Color
PC not connected.
If an Ethernet cable is connected to the PC ETH 1 port but no
one uses the tool, the LED remains blank.
Connection set up and in operation, for example, DHCP is
active and at least one PC has got an IP-address
DHCP server is active.
NETA-21 provides IP addresses for local devices.
At least one user has been logged on to the user interface
Factory-level access/operation.
Firmware update in progress.
Note: System status (STAT LED) blinks during the firmware
update.
Power off
Power on
Timed power off or standby.
NETA-21 can go to the standby mode as a protective measure
(eg, if the environmental temperature is too high).
To wake up the NETA-21, press the SD RJ45 button.
System in operation, OK
System starts up, services not yet fully operational
System waits for a confirmation of the reboot operation or
network override.
Firmware update in progress
Error occurred during the start-up of the NETA-21.
If the start-up fails, the NETA-21 restarts itself automatically
after a few seconds. During the reboot operation, all LEDs
excluding the PWR LED flash before the STAT LED turns
yellow again.
Note: If the yellow STAT LED and blinking red STAT LED
alternate and the STAT LED does not turn green, the start-up of
the NETA-21 fails continuously. Try resetting the NETA-21 to
factory settings.
NETA-21 sends data (eg, email) to an external destination.
NETA-21 fails to send data (eg, email) to an external
destination. Log on to the web user interface and go to
Reports –> Events for error details.
3BHS221906 ZAB E01 Rev. D
Chapter 10 - Preventive and corrective maintenance
Function
10-15 (36)