ABB
10.4
Removing the CDP control panel
Meaning of the LEDs
5k A UM
1
When the panel is removed while the drive is in operation, check the
setting of parameter 31.01 PANEL LOSS SUPERVISION first.
If the parameter is set to NOT USED, the panel can be removed
without interrupting drive operation.
For information on setting parameters, see
parameter
table.
When the CDP control panel has been removed during operation,
the drive can only be stopped by pressing the EMERGENCY-OFF
pushbutton.
2
To remove the panel, proceed as illustrated below.
1
The green LED
(4)
signals that the control voltage has been switched on.
3BHS221906 ZAB E01 Rev. D
Chapter 10 - Preventive and corrective maintenance
Appendix G – Signal and
2
3
4
10-7 (36)