Actual Signals Mode; Overview - ABB ACS5000 User Manual

Chapter 9 - CDP control panel
9.5

Actual signals mode

9.5.1

Overview

Actual values
9-4 (24)
After another few seconds, the display changes to the actual signals
mode. The status line of the display alternates between DCGnd NOpen,
NotReadyOn.
1 L ->
DCGndNopen
StateINU
MOTOR SP 0.00 rpm
POWER
0.0 kW
Two displays can be selected in the actual signals mode:
■ Actual signals display
■ Fault memory display
The actual signals display appears first when entering the actual signals
display mode. However, when the drive is in a fault condition, the fault
memory display appears instead.
The actual signals display is used to monitor the drive without interfering
with its operation. It continuously displays three selectable actual values..
The CDP control panel automatically returns to the actual signals display
from other modes if no key is actuated within one minute (an exception
from this is the fault memory display).
The actual values are organized in groups.
Group 01 Measured or calculated motor values
Group 02 Measured or calculated drive values
Group 03 Reference values
Group 04 Status signals of S800 I/O system
Group 05 Communication link and MCB status signals
Group 06 Software version, drive and motor nominal values
Group 07 Control words
Group 08 Status words
Group 09 Fault and alarm words
3BHS221906 ZAB E01 Rev. D
0.0 rpm
ABB
DCGnd Nopen
NotReadyOn
5k A UM