Chapter 6 - Electrical installation
6.8.7
Final checks
6.9
Power supply cables for fan units
6-20 (22)
•
Check that the entry plates are fastened properly.
•
Check that the cable glands fit tightly.
•
If EMC entry plates with rubber grommets are used, check that the
grommets fit tightly. If necessary, seal the gaps with silicone rubber.
•
Connect the power supply cable
corresponding socket
the coupling ring
Fig. 6-18
Fan – Power supply connector
3BHS221906 ZAB E01 Rev. D
(Fig. 6-18: 1)
(Fig. 6-18: 2)
on the roof of the cabinet. Tighten
(Fig. 6-18: 3)
carefully
1
3
2
ABB
of each fan to the
5k A UM