Huawei Eudemon8000E Series Manual page 70

HUAWEI Eudemon8000E Firewall
Hardware Description
Table 3-15 Buttons and indicators on the panel of the SRUA
Indicator/
Button
OFL button
OFL indicator
(red)
RUN indicator
(green)
ALM indicator
(red)
ACT active/
standby indicator
(green)
Reset button
CF ACT indicator
(green)
CF OFL button
SFP LINK/ACT
indicator (green)
MGMT-ETH
LINK indicator
(green) (on
Ethernet
interfaces)
MGMT-ETH
ACT indicator
(amber) (on
Ethernet network
interfaces)
Table 3-16
Issue 01 (2012-11-07)
Description
To remove a board, you must press and hold the button for six seconds
until the OFL indicator turns on.
This button takes effect only on the slave SRUA.
If the indicator is on, you can remove the board.
If the indicator blinks once every two seconds (0.5 Hz), the system is in
the normal state.
If the indicator blinks twice each second (2 Hz), the system is in the
alarm state.
If the indicator is steady on, the system is in the alarm state.
If the indicator is steady off, the system is in the normal state.
If the indicator is steady on, the SRUA is in the active state.
If the indicator is off, the SRUA is in the standby state.
If you press the Reset button, you can reset the main control unit on the
SRUA.
If the indicator is on, the CF is in position.
If the indicator is blinking, data is being read or written.
If the indicator is off, the CF is not in position or can be removed.
If you press the CF OFL button, all operations on the CF card will be
ended and the CF card will be powered off.
If the indicator is steady on, the link is normal.
If the indicator is blinking, data is being transmitted.
If the indicator is steady on, the link is normal.
If the indicator is off, the link is Down.
If the indicator is blinking, data is being transmitted.
If the indicator is off, no data is being transmitted.
lists the interfaces on the SRUA and their uses.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 E8000E-X8 Chassis Overview
60