Huawei FusionModule2000 Product Description page 184

FusionModule2000 Smart Modular Data Center
Product Description
Specifications
Table 8-42 Access actuator technical specifications
Item
Power input
POE port
Wireless
communication
AI/DI port
DO/DI port
RS485 serial port
expansion
Wiegand interface
BLINK button
Address DIP
switch
E-label
Indicators
Table 8-43 Access actuator indicator description
Indicator
PWR
RUN
Issue 06 (2020-05-21)
Specifications
 DC input: Terminal, with input voltage of 36–60 V DC

POE input: One POE port that complies with IEEE802.3at.
FE communication, 10/100M communications rate
One wireless communication port that complies with IEEE802.15.4,
mutual backup with FE communication
Two AI/DI ports, can connect to the fire alarm and exit button
 One 12 V DC power output that controls magnetic locks, terminal

One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communications rate of
9600 bit/s, physical port cascading supported (reserved function)
Two Wiegand interfaces, 12 V DC card reader operating power
output; two routes of card readers (non-fingerprint readers) can
operate at the same time.
 Press the button for less than 1 second to start blinking.
 Hold down the button for 1–5 seconds to search for a network and
start networking.
 Hold down the button for more than 10 seconds to clear network
parameters.
4-pin address DIP switch
Supported
Color
Green
Green
Copyright © Huawei Technologies Co., Ltd.
8 Intelligent Module Management System
Name
Power input status
indicator
Communication status
indicator
Status
 Steady on: The power
input is normal.
 Off: There is no
power input.
 Off: The power is
abnormal or the
board program is
loading.
 Blinking at long
176