Operator Seat - Toro Sand Pro 3040 Service Manual

Operator Seat

Removing and Installing the Operator Seat
Sand Pro ® 3040 and 5040
20251SL Rev A
g354857
1. Seat back cover
2. Seat cushion cover
3. Track assembly
4. Seat base
5. Slic pin (2 each)
6. Wire harness connector
7. Switch actuator cap
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Raise the seat and disconnect the electrical connector from the seat switch.
3. Inspect the rubber seat bumpers for wear or damage and replace them as
necessary.
4. Remove and install the seat components as necessary.
5. Connect the wire harness to the seat switch and test the seat switch
operation before returning the machine to service.
Figure 102
8. Seat switch
9. Flange nut (4 each)
10. Receptacle – rubber
11. Centering post – rubber
12. Spacer
13. Bumper – rubber (2 each)
FF
Page 7–25
position and remove the key
Chassis: Service and Repairs