Hydraulic Switch Kit Manifold (Optional) - Toro Sand Pro 3040 Service Manual

Hydraulic Switch Kit Manifold (Optional)

g352652
1. Flat plain (3 each)
2. Cap screw
3. Cap screw (2 each)
4. Coupler panel
Removing the Hydraulic Switch Kit Manifold
Sand Pro ® 3040 and 5040
20251SL Rev A
5. Cap screw (2 each)
6. Clamp
7. Hydraulic manifold assembly
8. Manifold bracket
Refer to Figure 74 for this procedure.
1. Remove the hydraulic tank; refer to
5–66).
2. Clean the hydraulic hose ends, and fittings on the manifold to prevent
contaminants from entering into the hydraulic system.
3. Label and remove the hydraulic hoses from the fittings on the manifold. Allow
the tubes and hoses to drain into a suitable container.
4. Install clean caps and plugs on the hydraulic hoses, and fittings to prevent
system contamination.
5. Label and disconnect the wire harness connectors from the solenoid valves.
6. Remove the fasteners securing the manifold bracket to the machine.
Note: The manifold bracket should be loose once the hydraulic tank clamps
have been removed.
7. Support the manifold assembly, remove the fasteners securing the coupler
panel and the manifold assembly to the hitch tube and remove the manifold
assembly from the machine.
8. Dismantle the manifold assembly if necessary; refer to
Hydraulic Switch Kit Manifold (page
9. If the hydraulic fittings are to be removed from the manifold, mark the fitting
orientation for assembly purposes and remove the fittings from the manifold.
Discard the O-rings from the fittings.
Figure 74
10.
Removing the Hydraulic Tank (page
5–119).
Page 5–117
9. Hydraulic tank clamp
Lock nut
Servicing the Optional
Hydraulic System: Service and Repairs