Servicing The Steering Gear Box (Model 08743) - Toro Sand Pro 3040 Service Manual

Servicing the Steering Gear Box (Model 08743)

g354537
1. Retaining ring
2. Retaining ring
3. Ball bearing (2 each)
4. Spacer
Disassembling the Steering Gear Box
Chassis: Service and Repairs
5. Pinion gear
6. Gear box cover
7. Bushing (2 each)
8. Sector gear
1. Remove the retaining ring that secures the pinion gear assembly in the
steering cover. Pull the pinion gear and bearings from the gear box cover.
2. Remove the fasteners that secure the gear box plate to the gear box cover.
3. Remove the gear box plate, gasket, shim(s) and the sector gear from the
gear box cover.
4. If necessary, remove the bearings from the pinion gear:
A. Remove the retaining ring from the pinion gear shaft.
B. Press the bearings and spacer tube from the pinion gear shaft.
C. Discard the removed bearings.
5. If necessary, remove the bushings from the gear box cover and the gear
box plate.
6. Thoroughly clean all the steering gear box components. Inspect the
components for wear or damage and replace them if necessary.
Figure 97
10.
11.
12.
Page 7–16
9. Shim (as required)
Gasket
Gear box plate
Cap screw (8 each)
Sand Pro ®
20251SL Rev A
3040 and 5040