Steering Gear Box (Model 08743) - Toro Sand Pro 3040 Service Manual

Steering Gear Box (Model 08743)

Removing the Steering Gear Box
Chassis: Service and Repairs
g354690
1. Cap screw
2. Lock nut
3. Bearing set screw
4. Steering wheel and shaft assembly
5. Cotter pin
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove the fuel tank; refer to
4–12).
3. Remove the fasteners that secure the steering shaft to the steering gear box.
Note: If removing the steering wheel is necessary; refer to
Installing the Steering Wheel (page
4. Loosen the set screw that secures the extended race of the steering shaft
bearing to the steering shaft.
5. Lift on the steering wheel and shaft assembly to separate the steering
shaft from the gear box pinion shaft. Position the steering wheel and shaft
assembly away from the gear box.
6. Remove the cap from the top of the steering gear box.
7. Remove the flange nut that secures the steering gear box to the front fork
shaft.
Figure 96
6. Slotted hex nut
7. Woodruff key
8. Steering gear box
9. Flange nut
10. Cap
FF
Removing and Installing the Fuel Tank (page
7–13).
Page 7–14
position and remove the key
Removing and
Sand Pro ® 3040 and 5040
20251SL Rev A