Traction Relief Manifold - Toro Sand Pro 3040 Service Manual

Traction Relief Manifold

Removing and Installing the Traction Relief Manifold
Sand Pro ® 3040 and 5040
20251SL Rev A
g352482
1. Traction relief manifold
2. Manifold bracket
For cartridge valve service procedures, refer to
Valve (page 5–87).
The traction relief manifold is located near the left rear wheel and is best
accessed from under the machine.
Review and follow the
the machine.
1. Raise all of the wheels off the ground and support the machine with jack
stands.
2. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
3. Clean the fitting and hydraulic hose connections before disconnecting the
hydraulic hoses to prevent system contamination.
4. Label all hydraulic connections for assembly purposes and disconnect the
hydraulic hoses.
5. Cap the fittings and plug the hydraulic hoses to prevent system contamination.
6. Remove the fasteners securing the manifold to the bracket and remove the
manifold assembly from the machine.
Figure 57
(view from under machine)
3. Hydraulic hose (2 each)
WARNING
Jacking Instructions (page 1–6)
Page 5–83
Servicing a Hydraulic Cartridge
before lifting
General Precautions for
Hydraulic System: Service and Repairs
5–54).