Toro Sand Pro 3040 Manual

Drag Mat Carrier System
Sand Pro
Model No. 08756-Serial No. 260000001 and Up
This product contains a chemical or chemicals known to the State of California to

Introduction

Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready. Figure 1 identifies the location of the
model and serial numbers on the product. Write the numbers
in the space provided.
1. Model and serial number location
© 2016-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® /Infield Pro
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Figure 1
Register at www.Toro.com.
® 3040 and 5040 Traction Unit
WARNING
CALIFORNIA
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety-alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
Contents
Introduction .................................................................. 1
Safety ........................................................................... 3
Safety and Instructional Decals ................................. 3
Setup ............................................................................ 3
1 Assembling the Drag Mat Carrier ............................ 4
2 Installing a Mat ..................................................... 5
3 Mounting the Drag Mat Carrier to the Traction
Unit ................................................................... 6
4 Adjusting the Link Assembly .................................. 7
5 Reading the Documentation and Storing the
Loose Parts......................................................... 7
Product Overview .......................................................... 8
Operation ..................................................................... 8
Restraining the Side-to-Side Pivot .............................. 8
Form No. 3406-765 Rev A
Installation Instructions
Figure 2
Original Instructions (EN) All Rights Reserved *3406-765* A
Printed in the USA
(Figure 2),