Steering Wheel - Toro Sand Pro 3040 Service Manual

Steering Wheel

Removing and Installing the Steering Wheel
Sand Pro ® 3040 and 5040
20251SL Rev A
g354677
1. Steering wheel cover
2. Lock nut
3. Flat washer
1. Carefully remove the steering wheel cover from the steering wheel.
2. Remove the locknut and flat washer that secure the steering wheel to the
steering control valve or steering shaft.
3. Use a suitable puller to remove the steering wheel from the steering control
valve or steering shaft.
4. Remove the foam collar.
5. Apply a small amount of anti-seize lubricant to the splines of the steering
control valve or steering shaft, then install the foam collar and the steering
wheel.
6. Secure the steering wheel to the steering control valve or steering shaft
with the flat washer and lock nut. Tighten the lock nut from 28 to 35 N·m
(20 to 26 ft-lb).
7. Install the steering wheel cover.
Figure 95
(model 08745 shown)
4. Steering wheel
5. Foam collar
6. Steering shaft
Page 7–13 Chassis: Service and Repairs