Toro Workman GTX Service Manual page 60

Transaxle
5
RIGHT
FRONT
1. Engine
2. Transaxle assembly
3. Swing arm
4. CVT drive belt
5. Primary clutch
CAUTION
The engine, exhaust system and drive system
components may be hot. To avoid possible
burns, allow all components to cool before work-
ing on drive system components.
IMPORTANT: Torque tighten the fasteners based on the fastener
grade. Make sure to use the correct torque; refer to Figure 17.
Drive Train
7
8
6
Grade 8
Grade 5
6. Secondary clutch
7. Cap screw
8. Stepped washer
9. Spanner bar
10. Flange head screw (3 used)
Page 4 - 18
39 to 47 ft- lb
(53 to 63 N- m)
4
10
9
12
Figure 17
Transaxle Removal (Fig. 17)
1. Park vehicle on a level surface, stop engine, set
parking brake and remove key from the key switch.
2. Remove cargo bed from the frame (see Cargo Bed
in the Service and Repairs section of Chapter 7 - Chas-
sis).
3. Remove drive belt from the primary and secondary
clutches (see CVT Drive Belt in this section).
25 to 31 ft- lb
(34 to 42 N- m)
200 to 230 in- lb
(23 to 25 N- m)
77 to 95 ft- lb
(105 to 128 N- m)
1
11
Antiseize
13
Lubricant
11
12
2
3
11. Flange head screw (4 used)
12. Lock nut (4 used)
13. Sway bar link bracket (2 used)
14. Stabilizer bracket
Workman GTX Gasoline
v
14