Toro Workman GTX Service Manual page 117

Tools for Frame Extension Kit
Use this tool kit (shown in Fig. 4) when installing or ser-
vicing the vehicle frame extension kit. The installed kit
is shown in Figure 5.
When the front and rear frame components are separat-
ed, the rear frame of the machine can be supported with
the legs included in this tool kit. The legs attach to the
rear frame with two (2) flange head screws and nuts for
each leg.
The bridge assembly is used to stabilize the swing arm
assembly to the rear frame when the swing arm is dis-
connected from the front frame. Install bridge assembly
as follows:
1. Remove flange head screw (item 2 in Fig. 6) that se-
cures the right, front corner of the throttle bracket. There
is no need to remove flange head screw that secures
R--clamp (item 3 in Fig. 6) to engine.
2. Install threaded rod from tool kit fully into the engine
and secure rod to engine with flange nut from tool kit.
3. Place bridge onto installed threaded rod making sure
that the bridge extends across both rear frame tubes.
4. Secure bridge in place with second flange nut from
tool kit. Do not over--tighten flange nut.
Toro Part Number: TOR6040
Workman GTX Gasoline
7
5
1. Threaded rod
2. Flange nut (2 used)
3. Bridge
4. Flat washer
1
2
1. Bridge
3
1. Throttle bracket
2. Flange head screw
Page 6 - - 5
4
3
1
2
6
5
Figure 4
5. Leg (2 used)
6. Screw (4 used)
7. Flange nut (4 used)
Figure 5
2. Leg (RH shown)
1
2
Figure 6
3. R- -clamp
Chassis