Toro Workman GTX Service Manual page 137

Disassembly (Fig. 21)
1. Park vehicle on a level surface, stop engine and re-
move key from the key switch. Chock wheels to prevent
the vehicle from moving.
2. Disconnect both parking brake cables from rear
brake calipers (Fig. 22):
A. Make sure that parking brake is released.
B. Loosen parking brake adjustment by loosening
lock nut and then loosen parking brake rod two (2)
turns.
C. Rotate brake lever on caliper toward front of vehi-
cle and hold lever in place. Carefully pull parking
brake cable to release cable conduit from caliper
bracket and then rotate parking cable to allow re-
moval of cable end from parking brake lever.
D. Position disconnected parking brake cable away
from brake caliper.
3. Carefully separate parking brake cables from four (4)
clips on swing arm.
4. Remove dash and position it toward the front of the
vehicle to allow access to parking brake cables and
brake lever (see Dash in this section). It is not necessary
to remove choke cable from dash.
5. Loosen the jam nuts that secure parking brake
cables to parking brake mount.
6. Remove clevis pin and hair pin that secure cable
equalizer bracket (item 6) to parking brake link.
7. Remove parking brake cables from cable equalizer
bracket. Once cables are removed from equalizer, re-
move ends of brake cables from jam nut and brake
mount.
8. Note routing of brake cables for assembly purposes.
9. Carefully remove brake cables by pulling them
through front frame toward front of vehicle.
10.If necessary, remove parking brake lever compo-
nents using Figure 21 as a guide.
Assembly (Fig. 21)
1. Install removed parking brake lever components us-
ing Figure 21 as a guide.
2. Carefully route parking brake cables through the
front frame and toward the rear wheels using cable rout-
ing noted during disassembly. Position the brake cables
in the vehicle so that the cable ends are close to the rear
brake calipers and the parking brake lever assembly.
Workman GTX Gasoline
3. Secure brake cables to parking brake lever assem-
bly:
A. Insert both brake cable ends through parking
brake mount and then through jam nuts.
B. Insert both cable ends into cable equalizer brack-
et.
C. Secure cable equalizer bracket with attached ca-
ble ends to parking brake link with clevis pin and hair
pin.
D. Install and tighten the jam nuts to secure parking
brake cables to parking brake mount.
4. Connect both parking brake cables to rear brake
caliper (Fig. 22):
A. Make sure that parking brake is not applied.
B. Insert parking brake cable end into parking brake
lever.
C. Rotate brake lever on caliper toward front of vehi-
cle and hold lever in place. Then, insert cable into
caliper bracket and slowly release brake lever to
align cable conduit with caliper bracket.
D. Secure brake cables to swing arm with four (4)
clips.
5. Adjust parking brake on both rear wheel calipers
(see Parking Brake Adjustment in the Adjustments sec-
tion of this chapter).
6. Check parking brake operation.
7. Carefully position and secure dash to vehicle (see
Dash in this section).
1
2
6
1. Parking brake cable
2. Cable conduit
3. Cable end
Page 6 - - 25
3
4
5
Figure 22
4. Parking brake lever
5. Lock nut
6. Parking brake rod
Chassis