Transaxle Shift Cable; Removal - Toro Workman GTX Service Manual

Transaxle Shift Cable

10
RIGHT
FRONT
1. Swing arm
2. Engine
3. Spanner bar
4. Transaxle assembly

Removal

1. Park machine on a level surface, stop engine, set
parking brake and remove key from the key switch.
2. Raise and support cargo bed to access the end of
shift cable at the transaxle.
3. Remove dash and position it toward the front of the
vehicle to access the end of the shift cable at the shift
lever (see Dash in the Service and Repairs section of
Chapter 6 − Chassis). It is not necessary to remove
choke cable from dash.
Drive Train
3
1
Figure 14
5. Shift arm
6. Flange head screw
7. Flange nut
8. Ball joint
Page 4 − 16
11
9
2
7
9. Lock nut
10. Shift cable
11. Shift cable jam nut
4. Disconnect shift cable from transaxle (Fig. 14):
A. Loosen jam nuts that secure shift cable to span-
ner bar (item 3). Separate cable from spanner bar.
B. Remove ball joint (item 8) from shift arm on
transaxle. Then, remove ball joint from end of shift
cable.
C. Carefully separate shift cable from clip on swing
arm.
8
5
6
90 to 110 in−lb
(10.2 to 12.4 N−m)
4
Workman GTX Gasoline
v