Toro Workman GTX Service Manual page 51

CAUTION
The engine, exhaust system and drive system
components may be hot. To avoid possible
burns, allow all components to cool before work-
ing on drive system components.
Drive Belt Removal (Fig. 7)
1. Park vehicle on a level surface, shut engine off and
engage the parking brake. Remove key from the key
switch. Place gear shift lever in the neutral position.
2. Allow engine, exhaust system and drive system to
cool before working on drive system.
Workman GTX Gasoline
3. Raise and support vehicle cargo bed to allow access
to drive system.
4. While rotating the secondary clutch, route CVT drive
belt from the secondary clutch sheaves.
5. Remove drive belt from from the primary clutch and
vehicle.
Drive Belt Installation (Fig. 7)
1. Place CVT drive belt around primary clutch.
2. Position drive belt to secondary clutch. While rotat-
ing the secondary clutch, route belt into position be-
tween secondary clutch sheaves.
3. Lower and secure vehicle cargo bed (if installed).
Page 4 − 9 Drive Train