Joining Water Pipes; Removing A Pipe Joint - ABB ACS5000 User Manual

5.12

Joining water pipes

1. Mark the length of a pipe joint on one end of a water pipe as a
fitting guide.
2. Slide the pipe joint over the two adjoining pipe ends.
3. Center the pipe joint.
4. After adjusting a pipe joint, alternately tighten the bolts lightly.
5. Tighten the bolts to the torque indicated on the pipe joint.
5.12.1

Removing a pipe joint

If you need to remove a pipe joint, proceed as follows:
1. Loosen the bolts alternately but do not remove them completely.
2. Slide the pipe joint to the side.
3. The sealing lip may touch the pipe end.
4. Turn and move the pipe joint smoothly.
5. Clean the pipe joint and treat the bolts with an appropriate lubricant
before refitting.
3BHS799208 E01 REV E ACS5000 WATER-COOLED USER MANUAL
05 MECHANICAL INSTALLATION
47 mm
86/186