General Notes On Installation; Dimensions And Clearances; Rear And Top Access To The Cabinet; Cabinet Roof - ABB ACS5000 User Manual

5.3

General notes on installation

▲
NOTICE
Risk of component damage,
Observe the following during installation:
• Ensure that no dirt enters the drive.
Always close the doors when work is discontinued and completely
cover openings. Metallic dust in particular may cause failures when
the drive is powered up and cause damage.
• When joining two transport units, do not damage or dislocate the
EMC sealing strip that is glued onto the outer joining surfaces of
the cabinet frame.
• If the transport units are joined but not yet on the base frame, do
not lift and move them with a crane.
Instead, use appropriate transport means, such as heavy load
hydraulics rollers or air cushions.
5.4

Dimensions and clearances

Note: For information on dimensions, location and size of fixing holes and
clearances, see "Appendix C – Mechanical drawings".
5.4.1

Rear and top access to the cabinet

Joining the transport units and DC busbars requires rear and top access.
5.4.2

Cabinet roof

The cabinet roof is not designed as a base for foreign devices or cable
ducts. Therefore, do not install any foreign objects on the roof.
5.4.3

Fire protection

To prevent fire from spreading into the drive, apply suitable fire
protection measures.
5.4.4

Cable duct material

Use cable ducts of non-flammable material with non-abrasive surface.
To prevent dust, humidity and animals from entering the drive, protect all
cable entries and exits of cable ducts.
5.4.5

Installation material

Installation material is supplied with the drive in a separate box.
5.4.6

Tools

See "1.12 Tools" on page 28.
3BHS799208 E01 REV E ACS5000 WATER-COOLED USER MANUAL
05 MECHANICAL INSTALLATION
74/186