Upgrade Through Cli - Huawei USG6000 Upgrade Manual

HUAWEI USG6000&USG9500
Upgrade Guide
Upgrade Mode
NOTE

2.2.5.2 Upgrade Through CLI

Upgrade Flow
Figure 1shows the flow of upgrading the version software through CLI.
Figure 2-5 Flowchart of the version software upgrade through the CLI
Procedure
Step 1 On PC2, log in to the USG9500 through FTP. FTP is used only as an example. You are
advised to use SFTP to transfer files to secure data transfer.The following uses the Windows
FTP client as an example. In practice, you are advised to use a legitimate third-party FTP
client (such as Cute FTP) to transfer files.
The following uses the Windows FTP client as an example. In practice, you are advised to use
a legitimate third-party FTP client (such as Cute FTP) to transfer files.
If the FTP connection established for backing up the important data to CF card 1 remain,
perform Step 2; if the FTP connection has timed out, log in again.
Issue 01 (2018-01-16)
Application
Scenario
The mentioned version software includes the system program (*.cc), PAF file, Sensitive Feature
Component Package and license file.
Version software must be stored in CF card 1. CF card 1 is located in the circuit board of the MPU and
mainly used to store the version software and configuration file. CF card 2 is located in the panel of the
MPU and mainly used to store log and alarm information.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Strength
2 USG9500
Prerequisites
143