Huawei USG6000 Upgrade Manual page 143

HUAWEI USG6000&USG9500
Upgrade Guide
3.
4.
Preparing for the Environment for the Upgrade Through CF card
When you use a CF card to upgrade the device, no network environment is required for
transferring the version software. However, to verify the upgrade result, you still need to issue
commands. Therefore, you need to build up an environment in which you can log in to the
device through the console port, telnet, or SSH.
Preparing the Environment for the Upgrade Through BootROM
During the device startup, you can access the BootROM menu. In BootROM environment,
transfer the version software to CF card 1 of the device, specify this version software for the
next startup, and restart the device.
Use interface GigabitEthernet 0/0/0 on the MPU of the USG9500 to transfer the version
software.
The USG9500 currently allows you to transfer the version software to CF card 1 through FTP
or TFTP in the BootROM menu. No matter you use FTP or TFTP, the USG9500 functions as
the client that downloads the version software from the FTP or TFTP server.Figure 3 shows
the network for this case. In both modes, you must install third-party FTP or TFTP server
software on PC2.
Issue 01 (2018-01-16)
[sysname-aaa-manager-user-webuser]quit
[sysname-aaa]quit
On PC2, configure an IP address in the same network segment as GigabitEthernet 0/0/0.
Log in to https://192.168.0.1:8443 using the Internet Explorer on PC2 to verify the
configurations.
If the login interface of the Web server is displayed in the IE browser, and the login
succeeds through webuser and Admin@123, it indicates that you can log in to the Web
server normally.
After the configuration is verified, you can either keep this connection for further use, or
exit from the Web server and relog in to it when required.
Configure the FTP server.
This document does not provide the details about the FTP server program. Obtain the
FTP server program in a legitimate way, and configure the program according to related
documents. Assume that you have already created an FTP user account whose name is
123 and password is 123, and specified the root directory of the user as the directory for
saving the downloaded files.
NOTICE
NOTE
You can use only one PC on which you run both the HyperTerminal program and the FTP/TFTP server.
To facilitate description, the network using two PCs is used as an example. The following steps apply to
this two-PC network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 USG9500
134