Huawei USG6000 Upgrade Manual page 140

HUAWEI USG6000&USG9500
Upgrade Guide
l
l
Use interface GigabitEthernet 0/0/0 on the MPU of the USG9500 to transfer the version
software. If you use an interface on the LPU to transfer the version software, use the FTP
service but not the TFTP service for transfer.
The following is an example in which the USG9500 functions as an FTP server. This method
is easy because it does not require a third-party FTP server. For details on other modes, see
"Appendix: Uploading and Downloading
files to secure data transfer.
As shown in Figure 1, the USG9500 is configured as the FTP server and version software is
located on PC2 serving as the FTP client. On PC2, log in to the FTP server and upload the
version software to CF card 1 of the USG9500 through FTP.
Figure 2-2 Schematic diagram of the USG9500 serving as the FTP server
Perform the following steps to configure the USG9500 as the FTP server:
1.
Issue 01 (2018-01-16)
TFTP mode with the USG9500 as the TFTP client
SFTP mode with the USG9500 as the SFTP server
NOTICE
NOTE
You can use only one PC on which you run both the Telnet/SSH client and the FTP client. To facilitate
description, the network using two PCs is used as an example. The following steps apply to this two-PC
network.
On PC1, log in to the CLI of the USG9500 through Telnet or SSH. For the Telnet or SSH
login method, see the related configuration example in
HUAWEI USG6000&USG9500 V500R001C80SPC100 Product Documentation
.
You are recommended to use interface GigabitEthernet 0/0/0 on the MPU of the
USG9500 for login. By default, the IP address for interface GigabitEthernet 0/0/0 is
192.168.0.1, the user name is admin, and the password is Admin@123.
If both MPUs can be detected, use GigabitEthernet 0/0/0 on the active MPU for the
upgrade. You can check whether the MPU is active through the ACT indicator on it. If
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Files." You are advised to use SFTP to transfer
2 USG9500
131