Toro 260 Series Service Manual page 71

6. Disconnect the hydrostatic control rod from the
forward/reverse pedal (Figure 152).
Figure 152
7. Loosen the left side support clamp for the pedal
pivot shaft and remove the right side support
clamp (Figure 153).
Figure 153
260 Series Tractor Service Manual
HYDRO-GEAR TRANSAXLE
8. Drive the brake cross shaft and pedal out the
right-hand side of the tractor enough to get
clearance to install the drive belt above the shaft
(Figure 154).
MVC-185X
9. Install belt around and above the electric clutch.
Feed the belt above the steering sector gear and
over the pedal pivot shaft. The right side of the
belt should wrap around the two idler pulleys, then
around the transaxle input pulley (Figure 155).
MVC-186X
Figure 154
Figure 155
MVC-187X
MVC-188X
4 - 13