Adjustments; Lift Height; Leveling; Side To Side - Toro 260 Series Service Manual

Adjustments

Lift Height

To obtain a positive latch when the lift handle is in the
full raised position, turn the ¾" nut on the lift rod, A, to
increase or decrease movement of the lift arm
assemblies, B and C.

Leveling

To position the two front lift arms parallel to the tractor
frame, disconnect the leveling rod, D, from the front lift
arms and turn the rod through the trunnion to alter its
length. This rotates the front lift arm assembly, C, on
the cross shaft, E.

Side to Side

When required, perform a side to side adjustment of
the rear lift arms by loosening and repositioning the
9/16" bolts found in the slots of the mounting brackets,
F.

Power Lifts

Electrohydraulic Lift (2000 and Prior Models)

Figure 60
For information on removal and repair of the
Electrohydraulic Lift, refer to Electrohydraulic Lift
Service Manual, Form Number 492-0704.
260 Series Tractor Service Manual

Electric Lift (2001 and Later Models)

(1) Actuator Bracket Assy.
(2) Clevis Pin
(3) E-Ring
(4) Pivot Bracket Linkage
(5) Flange Bearing
(6) Actuator
(7) Flat Washer

Removal

1. Remove the hoodstand side panels to the battery
compartment.
2. Disconnect the negative and positive cables from
the battery.
3. Remove the screws, 13, from the battery bracket,
12, and remove the battery bracket.
4. Unplug the actuator, 6, from the wiring harness.
5. Remove the e-ring, 3, from the end of the clevis
pin, 9.
MVC-470X
6. Remove the clevis pin, 9, washers, 7, and
spacers, 8.
7. Remove e-ring, 3, and remove clevis pin, 2.
8. Remove the actuator

Installation

Reverse the order of removal.
CHASSIS
Figure 61
(8) Spacer
(9) Clevis Pin
(10) Lift Arm Assembly
(11) Flat Washer
(12) Battery Bracket
(13) Screw
Electlift
2 - 21